Improved control operation for
– Fire alarm activities
– Operating conventional sounders
– Technical alarm features
– 230V relay outputs
• Improved service functionalities
– Extension of settable software parameters
– Firmware Update directly on the loop without removing the
transponder
• User optimized assembly and installation
– Support of multiple installation methods
• DIN-rail mounted, wall-mounted housing, integration in FACP
• Pluggable modules
• Improved terminals on board

• Enhanced housing concepts with more space for installation

Key
Day / Nigth
Activate/deactivate (if programmed) day/night mode.
Day mode active
Delayed
Verification delay
Delay function active (yellow) day mode
Illuminates to indicate that the >Day mode< function has been activated on the
fire alarm control panel.
Delay activated (yellow)
The programmed delay has been triggered by a fire alarm. Once the time delay
has elapsed, the alarm is automatically triggered unless the key for
investigating the cause of the alarm is pressed within this time.
Key
>Investigate activated< (yellow) display
Pressing this key will stop the delay function and start the programmed
investigation time. Once the investigation time has elapsed, the alarm is
automatically triggered unless the >Reset FACP< key for resetting the control
panel is pressed within this time.
Fire alarms can be set off manually at any time by triggering a manual fire
alarm.

Silenced (yellow)
The activated acoustic alarms have been acknowledged and silenced.
Depending on the programme, the alarm transmitters will be activated
again with each new alarm signal. The acoustic alarms can be silenced by
pressing the key and will be activated again in the case of new
events or can be reactivated manually (alternate function key).
Deactivated (yellow)
This key can be used to activate or deactivate (alternate function key) the
activation function for those relays of this control panel that were
programmed with the >acoustic alarm off< function in the customer data,
such as the relays to which acoustic and optical alarms are connected.
Deactivated components are optically shown in the common display
>DISABLEMENT<
.
This function can be manually switched on/off by pressing the key
(alternate function key).